#cp config/config.js.cn ~/MagicMirror/config/config.js #Display ChineseĤ. cd ~/MagicMirror/modulesĬp config/config.js.en ~/MagicMirror/config/config.js #Display English Install MMM-VoiceAssistant model and display. curl -sL | sudo -E bash -Īfter installing, run the command to display. Open the terminal and type the following commands. **** List of CAPTURE Hardware Devices ****ģ. If you can get the information below, it means that the driver was installed successfully. #dtparam=audio=onĪfter rebooting, check the driver by the following command. Modify the config.txt file, remove the following line from the file, or comment on it. Open the terminal and use the following commands to install. After booting, you can access Raspberry Pi via SSH, or directly connect the keyboard and mouse. Connect the Magic mirror to the network and power on Raspberry Pi. Save and insert the micro SD card into Raspberry Pi. Modify the config.txt file which is located in the BOOT directory, and add the following lines to the config.txt file. Create a new Txt file under the BOOT directory of the micro SD card and name it SSH. Write Raspbian image Download the lasted Raspbian image from the Rasberry Pi website and write it to an empty micro SD card. Inset the card to Raspberry Pi and power on it. Note: you need to change your_real_wifi_ssid and your_real_password" to the real ssid and password.ģ. (if you didn't find the files, create them.) ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev Add the following lines to wpa_nf files in the BOOT directory. Download the pre-configured image and write it to your TF card.Ģ. The pre-configured images have already installed the required libraries and drivers, and the program runs automatically after booting. It is recommended to install pre-configured images for newbies or first-time installations. The second method is to configure the environment running the program on the original image of the Raspberry Pi. Method one, using a pre-configured mirror. If you want to remove this error, remove otg_mode=1 in of config.txt, and add dtoverlay=dwc2, dr_mode=host (USB cannot be recognized without adding it). If you use the latest Raspberry Pi OS (image after October 30, 2021) USB2.0 is OTG mode by default, and CM4 will report an error:Ĭonfig failed, hub doesn't have any ports! (err -19) If you need to start, you need to add the following demo to the config.txt file: The USB port is disabled by default on the CM4 to save power. Write Image for Compute Module Boards Lite version.Write Image for Compute Module Boards eMMC version.75x75mm spacing mounting holes (M4 screw hole) for a general wall mount.Embedded Microphone and speaker, adopts Snowboy Hotword Detection Engine.Toughened glass capacitive touch panel, 6H hardness, supports up to 10-points touch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |